Re: [ihc] 1 inch body lift

[william cunningham <slypigs@xxxxxxxxxxx>]

Thanks Howard!
Now I need to find my 7/16 12 point to get that rag joint off.

Howard R Pletcher wrote:

>There should be no problems with a 1" lift other than you need to
>disconnect the steering rag joint while you are doing the lift as you
>will likely raise the body more than 1" while installing the lift.  It
>should work fine after you set the body back down.  There shouldn't be
>any problem with the shift levers, although getting to low range is where
>a problem usually first occurs so that's the spot to check.
>
>Howard
>
>
>On Sun, 09 May 2004 10:28:42 -0600 william cunningham
><slypigs@domain.elided> writes:
>
>>Are there any major issues associated with a 1 inch body lift, on a 
>>Scout II, other than:
>>Drop the shroud.
>>Keep an eye on the gas filler tube.
>>Make sure the shift levers clear/don't hit (manual tranny).
>>It looks like I may be able to get another inch of adjustment out of 
>>the clutch linkage.
>>The only other issue I can think of is the steering, hope its not as 
>>involved as a 2 inch lift.