Re: [ihc] Tool I need

To: bearbvd@xxxxxxxxxxxxxx (Greg Hermann)
Subject: Re: [ihc] Tool I need
From: John Hofstetter <hofs@xxxxxxxxxxxx>
Date: Tue, 9 Nov 2004 09:27:54 -0800
Cc: "ihc@xxxxxxxxxx digest" <ihc@xxxxxxxxxx>
Content-transfer-encoding: 7bit
Content-type: text/plain; charset=US-ASCII; format=flowed
In-reply-to: <v01510102bdb5f5f9521f@[67.234.181.138]>
References: <v01510102bdb5f5f9521f@[67.234.181.138]>
Reply-to: John Hofstetter <hofs@xxxxxxxxxxxx>
Sender: owner-ihc@xxxxxxxxxx

On Nov 8, 2004, at 8:22 PM, Greg Hermann wrote:

Because what you REALLY need would be what I have--a 3/4 drive torque
wrench that reads up to 600 ft lbs, and a 4:1 multiplier that is 3/4 drive
in, 1" drive out---

Greg :-)

Hey Greg,

I don't need a torque wrench, I already know that it's too darn tight for what I have around to try and get it off. <g>

Besides that, if I was using your multiplier, then I'd have to have 1" drive sockets.

John

John Hofstetter
Ol' Saline
www.goldrush.com/~hofs

References:
- Re: [ihc] Tool I need
  - From: Greg Hermann

Prev by Date: RE: [ihc] Factory Toe-In Spec, Anyone?
Next by Date: [ihc] Wheel Alignment
Previous by thread: Re: [ihc] Tool I need
Next by thread: RE: [ihc] Tool I need
Index(es):
- Date
- Thread

Home | Archive | Main Index | Thread Index