RE: [ihc] transmission lines

["Jim Grammer" <jgrammer@xxxxxxxxxx>]

>-----Original Message-----
>From: owner-ihc@domain.elided [mailto:owner-ihc@domain.elided]On Behalf Of
>spamaddy@domain.elided
>Sent: Monday, September 20, 2004 3:00 PM
>To: ihc@domain.elided
>Subject: RE: [ihc] transmission lines

>Is it possible to use rubber hose (heater hose?) instead of the tubing or
>would there be too much pressure?  Can the nuts that go on the end of the
>lines be obtained at an auto parts store like Napa?

It has been done, but I wouldn't. The proper hose is the same stuff used for
p/s return line. Not inexpensive, and it will need replaced every couple few
years.

Flare fitting hardware is normally available at better auto parts stores,
usually in the Dorman range.

Jim