Re: [ihc] RE: 800 4 speed

[bearbvd@xxxxxxxxxxxxxx (Greg Hermann)]

At 8:49 PM 8/16/04, JefGruwell@domain.elided wrote:
>In a message dated 8/16/2004 11:39:10 AM Pacific Standard Time,
>owner-ihc-digest@domain.elided writes:
>
>RE: 800  4 speed
>
>
>
>Can't the Scout II T-19 input shaft be machined, shortened and  re-splined to
>work for Scout 80/800?
>
>I was thinking about having this done at one point but stumbled into a  T-18.
>
>A wide Ratio T-19/196 combo would sure be nice in an  80/800.

Just shorten it. Run a clutch with the 1-1/4"-10 spline hub and a neutral
balanced V-8 flywheel---

I would suggest NOT cutting it shorter until the new pilot bearing diameter
(would be the same size as the old one) has been machined at the spot it
needs to be while the shaft is 'on centers' in the original center holes--
:-)

Greg

>
>Jeff G.