[ihc] Fuel pump pressure and delivery

["Joel M Brodsky" <jmbrodsky@xxxxxxxxxxxx>]

Hey Joe,
How about a clear plastic jug on top of the engine, and perform the same
test.  Look/watch for
flow and avoid fires.  Also, you should put a pressure gauge on the end of
the fuel pump delivery line and measure the line pressure, which should be
at least 7-10 psi.

Good Luck,
JoelB

Date: Thu, 25 Sep 2003 23:46:13 EDT
From: Archerzero@domain.elided
Subject: Subject: [ihc] Stall at warm up, CONT

Joe,

try this;

take the fuel line off the carb and wrap it up with a rag and turn the
engine
over for maybe five seconds. IF the fuel pump works the rag should be
soaked.
If the rag is only a tiny bit wet then replace the fuel pump. Fuel should
spray out of the line when its unattached. But try not to start a fire.
Fire very
very bad

andy