IHC/IHC Digest Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Wheel Alignment question
----- Original Message -----
From: "Ryan Moore" <baradium@domain.elided>
To: "David Bongo" <dbongo@domain.elided>; "IHC Digest"
<ihc-digest@domain.elided>
Sent: Monday, July 28, 2003 2:57 PM
Subject: Re: Wheel Alignment question
> ----- Original Message -----
> From: "David Bongo" <dbongo@domain.elided>
> To: "IHC Digest" <ihc-digest@domain.elided>
> Sent: Monday, July 28, 2003 15:30
> Subject: Wheel Alignment question
>
>
> > I'm looking for some general knowledge here. I got my Scout fixed from
> > the tie rod mishap, but the alignment is wrong. I brought it to the
> > tire place for an alignment, and they told me they couldn't do it. (I
> > later found out that they could do the toe-in, which is all I was
> > worried about -- after all, it was a tie rod problem I had.)
Big snip
The toe in is not real difficult to set. The main problem is to find a true
line that the tire rotates to. In order to do that jack up the tire so that
it rotates freely. Then as some one rotates the wheel, hold a marking
devise, ( I use a long screwdriver, with the blade turned on edge ) and
carefully holding it steady make a clear mark, near the center of the tread
around the circumference of the tire. Repeat for the other side. With both
wheels back on the floor, or driveway, drive ahead about the revolution of
the tire. Then from the closest to center height of the two wheels, measure
the distance between the marks on the back side of the tires then on the
front side. The difference between the two measurements should be between
1/16th " and 3/16th"s the front side being shorter. That is called "toe in"
and varies depending on size, make, year, condition of steering parts of the
vehicle.
I have set mine on the less toe in. If the toe in is too much, the front
has tendencies to dive or turn too fast too much. Not enough and the front
likes to wander.
If you do this job yourself, [approximately] one fourth of a turn on the
adjusting sleeve is [about] 1/16th of an inch on toe in adjustment.
Cheers Jim A.
Jim Aos
jaos@domain.elided
Okanogan, WA
72 1310 I.H.C 4x4 242000 miles
76 300D MB 263000 miles
83 Goldwing 202000 miles
94 F350 Turbo Diesel 180000 miles
http://www.geocities.com/eilofaos/eilof.html
Home |
Archive |
Main Index |
Thread Index