Re: Electrical Failure (Still)

[Eric Hegstrom <ehegstrom@domain.elided>]

Well since everything doesn't work it is most probably a single
connection is open. The only thing I can think of is to work back from
the battery. Maybe it's the Ammeter. Do you have an Amp guage? Doesn't
everything run through that (except the big wire for the starter). If
you do have one check if there's power on one side of it and not the
other. If so get a new one or make a jumper (of the same gauge or
thicker as the feed wire to it).

Peace,
Eric

Al Evitts wrote:
> 
> Guys:  Jiggled the bulkhead connectors looked for obvious burned wires,
> nothing.  Ignition switch is in Collum (sp) so no Fusible link by it
> that I know about. I don't understand why everything is out. That seems
> like battery but the cables and the battery all have power flowing to
> them. Anybody got any helpfull hints? I have a wiring diagram in a 78
> Shop Manual but some of these wires have been spliced and rerouted in 28
> years. Centech or Painless wiring  might be my only hope.  TIA
> 
> Al

-- 
Eric Hegstrom                          .~.
Senior Software Engineer               /V\  
Sonoran Scanners, Inc.                // \\          L I N U X
ehegstrom@domain.elided        /(   )\  >don't fear the penguin<
520-617-0072 x402                     ^^-^^