Re: Tach Question

[Eric Hegstrom <ehegstrom@domain.elided>]

I mean should NOT be hard to figure out. - Whoops time for more coffee.
peace, eric

Eric Hegstrom wrote:
> 
> Well I have the same setup and I know the following for sure:
> Black - ground (duh)
> Green - coil
> 
> I can't positively remember off hand which of the red/white goes for
> light and which goes for 12v, but that should be hard to figure out in a
> non-destructive sort of way.
> 
> Peace,
> Eric
> 
> Matt and Stacy Sopher wrote:
> >
> > Hi all,
> > I have a SunPro Minitach that I've had on my shelf for a few years now. Now
> > I'm finally going to put it in, but I have forgotten which wires go where!
> > There are four wires;
> > Red- power?
> > black- ground?
> > green- negative side of the coil?
> > white- hooked up for light?
> > Or do I have the green and white mixed up somewhere? I don't want to hook it
> > up and see if this is right, as I don't want to break it.
> > Thanks in advance,
> > Matt Sopher
> 
> --
> Eric Hegstrom                          .~.
> Senior Software Engineer               /V\
> Sonoran Scanners, Inc.                // \\          L I N U X
> ehegstrom@domain.elided        /(   )\  >don't fear the penguin<
> 520-617-0072 x402                     ^^-^^

-- 
Eric Hegstrom                          .~.
Senior Software Engineer               /V\  
Sonoran Scanners, Inc.                // \\          L I N U X
ehegstrom@domain.elided        /(   )\  >don't fear the penguin<
520-617-0072 x402                     ^^-^^